Pureco Eco Stripper user friendly paint stripper.  

It has a low odour, and a lot safer than the caustic and methylene chloride based paint strippers.  

Has a pleasant citrus odour and can be cleaned up in water.

Eco Stripper is one of the safer formulations for paint stripping.  

It employs less dangerous chemicals for stripping and removing paint, graffiti and for general industrial cleanup.  Unlike older methylene chlordide based paint strippers, Eco Stripper has much lower vapour pressure, that is it has much less fumes evaporating from it and what does evaporate is not as dangerous as the fumes from the older style paint strippers.

How to use-

1. Apply appropriate PPE i.e. gloves, goggles.  Always stir well before use.

2. Apply a thick coat (0.5mm to 1.0mm thick), by brush or roller. (2 square metres per litre.) As surface conditions vary, initially test on a small, obscure section to ensure suitability.

3. Immediately cover with sheets of plastic (e.g. Old Shopping Bags, Used Plastic Drop Sheet), and leave for about 20 minutes while applying to the next, adjacent area. Time needed may vary dependent on number of coats and age of coating.

4. Gradually peel back the plastic and remove the softened paint and residue with abroad paint scraper. We suggest plastic scrapers but metal is fine if used gently.

5. Wash the surface with a scourer and allow to dry.

6. Some more difficult coatings may require a further application to effect complete striping.

7. Surface is now ready for sanding and re-painting.

8. Clean up tools and clothes with soap (detergent) and water.

9. Remove contaminated clothing and wash before reuse.

 Pureco Lemon Myrtle Cleaner Liquid

All natural, Australian made, eco concentrate soap.
Toxin & sensitiser free.
Palm Oil & Phosphate free.

Divine smelling!

Perfect for cleaning furniture pieces, paint & wax brushes.

For brush cleaning - Rinse out any excess paint. use 1/2 pump into wet hand & scrub brush in circular motion. rinse well.

For furniture cleaning - Use 1 to 2 pumps into warm water in a bucket, bowl or spray bottle, wipe piece with soft damp cloth.

Wipe off residue with a clean damp cloth, wipe dry with clean lint free cloth after, ensure piece is fully dry before painting.

Re-use or recycle container once empty.
Grey water & septic safe. 

Pureco Gloss Sealer is a non-yellowing, easy to use, self levelling gloss sheen sealer, giving an invisible, easy-clean finish over your paint or surface! 

Exterior grade so safe for outdoor use!
1-2 coats recommended

100% washable! 

This sealer can be tinted using both ranges of our paint.

Pureco Gloss Sealer is quite a sticky consistancy and water can be added to help application. If spraying add up to 10% water. 600ml will cover 10-12 square metres.

How to use -

Stir contents thoroughly before and during use with a broad, flat stirrer, using an upward action.

Apply using a Pureco Sponge Applicator, brush, sprayer (can be diluted up to 10%), roller or wipe on using a damp lint free cloth.

Perfect to use for decoupage, transfers, gluing and sealing wallpaper or used as a image transfer medium as well.

600ml will cover 6–8 square meters depending on application technique and surface roughness.

Water clean up, product should not be used if air temperature is below 10 degrees or above 35 degrees.